John Deere Gator Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Wanting to add some additional driving lights for my 825i. As most know, there are pre-drilled holes on each side of front brush guard for lights and also an
area on the front below the OEM lights where you could add some round lights. I could also replace the OEM driving lights that came on
it as they are fairly useless. I have a switch bank overhead and have 2 available empty plates for a couple of new rocker switches.
Would appreciate any information on suggestions for lights, wiring and switches.
 

· Registered
Joined
·
2,936 Posts
Topic has been discussed before, so you might want to search the forums for some insight.

For wiring, tin coated copper wire is always a good choice.
 
1 - 2 of 2 Posts
Top