John Deere Gator Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
I am looking for a low profile roof for the gator. Anyone have suggestions or seen any aftermarket ones out there?
 

·
Registered
Joined
·
242 Posts
John Deere offer a few hard and soft tops...I have seen a few home made ones as well.
 

·
Registered
Joined
·
904 Posts
Only seen JD ones and homemade. I would say soft top is the lowest, but some ppl don't like them.
 

·
Registered
Joined
·
32 Posts
I spoke with jerry at dimondback the part number is JG512-R it is 239 plus 70 for shipping it is dimond plate aluminum they have linex ones a bit more dimondbackutv.com or 18772455080 hope it helps
 

·
Registered
Joined
·
904 Posts
Post up some pics of this roof please. Raw and Painted if possible.
 

·
Registered
Joined
·
114 Posts
 

·
Registered
Joined
·
242 Posts
I like the diamond plate roof!!!
 

·
Registered
Joined
·
114 Posts
Well I found a shop about a week ago that bends metal and they had diamond plate that was just big enough to make a roof. I should have it back early next week. I'll do all the mounting and I'll have to cut a notch for the brake light bracket.

Sheet of diamond plate runs about $135 and $50/hr for labor. Im hoping they dont charge me more than an hour...all they have to do is set the machine up and make 2 bends.
 
1 - 12 of 12 Posts
Top