Code 24 is a ground speed sensor error. Ecu isn't getting a signal from it. the sensor is on the forward side of the transmission on the lower portion near the starter for the engine. Check the wiring coming out of the sensor & up to the main harness. If it's OK the sensor may need to be replaced.

 

How about 2 long and 1 short flashes?

 

Thank you I will check that and see if it may fix the problem.

 

The information you seek can be found in the technical manual JD publishes. It's a great resource to have when troubleshooting your Gator.

After purchasing, you'll be in a great position to help others.

This link should help with finding the technical manual form JD: JD Manual Lookup

Agree with Bradhill to start a new thread with a title that represents you specific situation.

Welcome

 

I found the tech manual on EBay, I would answer your question, but it seems I have misplaced the manual...

 

I have a 2009 gator xuv with the exact same problem. I’ve replaced the ground speed sensor with no luck. Any other ideas
Thanks

 

Found the manual. The manual says the engine must be running above idle speed for the ECU to recognize the ground speed signal sensor. Maybe the ECU doesn't recognize the engine speed?

BTW, two long and one says the ECU is not getting the proper signal fro the MAP sensor.

 

thanks for the info. Do you know if there is a voltage reading I can take at the plug on the ground speed sensor to know if the ECU is recognizes it?
Thanks

 

I suspect you will need an oscilloscope to monitor the signal. The manual says something about a pulse signal.

 

Interesting thanks

 

So how was this resolved?